Instructions- Pre-Grading Solution/Card Spray

@miraclecardcare #CapCut ♬ original sound - miraclecardcare

 Pre-Grading Solution instructions: 

Step 1 - Place down a miracle card care cleaning mat or a gamer mat to protect your card. If you need to use CARD SPRAY to clean off any stuck dirt on your card do that step first. (Card spray instructions are below) 

Step 2 - Gently apply pre-grading solution with foam tip applicator to your cards holographic surface. (Pre-Grading Solution should only be used on holographic surfaces). 

 Step 3-

 wipe off solution with microfiber cloth in a small circular motion until solution is completely cleaned off (be sure to keep switching to dry piece of your microfiber cloth after every few rotations). We recommend 1-3 applications for the best results.  (When doing multiple applications do them consecutively without any wait time in between) 

Step 4-

After you think all the solution is completely off the card switch to clean cloth and wipe the card off a few more times to be 1000% sure all the solution is off.

Step 5- 

Be sure to fully inspect both sides of your card after cleaning under a high powered light to make sure you do not leave any solution behind/ residue behind on your card and to decide if you need another application. (Very Important) 

Step 6-

let your card air dry for about 15-20 minutes before placing back into a penny sleeve or top loader. Wipe access solution from applicator back into your container thoroughly and place applicator back into plastic baggie until next use. We do not recommend washing applicators. Once your applicator gets dirty it is time to replace. Microfiber cloths however can be washed in washing machine. Make sure microfiber cloth is fully dry before next use.

Card spray instructions:  (For removing dirt on your card)

Step 1 - 

place down a miracle card care cleaning mat or a gamer mat to protect your card. 

Step 2- 

spray 1-2 squirt onto cleaning pad or microfiber cloth(cleaning pad should only be very lightly damp) and wipe off dirt on your card (very lightly). Then immediately turn over cleaning pad and wipe off with dry side of cleaning pad (Do not spray card spray directly on your card). Card spray can be used on all surfaces to remove dirt. repeat process if needed. 

Step 3-

let your card air dry for about 7-10 minutes before placing back into a penny sleeve or top loader or before using PRE-GRADING SOLUTION.

Terms/Policies

For terms and Policies about our products be sure to visit our terms/policies page