Instructions- Plate Pro kit

@miraclecardcare #CapCut ♬ original sound - miraclecardcare

 

 

REDUCING/FIXING DENTS:

 IF USING PRE-GRADING SOLUTION ON YOUR CARD DO THAT FIRST AND LET THE CARD AIRDRY FOR 24 HOURS BEFORE DOING THESE PROCESSES

STEP 1: 

Give 2 card pads 2-3 light mist with PLATE PRO SPRAY. (Its important to apply applications from a fair amount of distance away so they are not direct sprays but only light mist so you DO NOT OVER SOAK THE PADS and so the pads are evenly distributed with the plate pro spray)

STEP 2:

Place card in between the 2 pads so that both misted sides are facing the card.

STEP 3:

Take the pads with the card inside and place in between the plates so logos are facing out. Then clamps plates down with the 4 blue clamps. Let the card rest there for 24 HOURS UNTOUCHED.

After the 24 hour wait period is up take the card out and inspect. Decide if you need to do another application. If so repeat STEPS 1-3 until satisfied or until no more improvement can be made.

STEP 4: 

Once your satisfied with the results. Let the card dry for approximately 2-3 DAYS in between the same pads and plates or until the card is completely flat and dry. 

STEP 5:

Once your card is flat and dry. Place your card into a penny sleeve and top loader or a semi rigid holder and leave the card in there for 2 WEEKS UNTOUCHED so the card can stay nice and flat.

@miraclecardcare #CapCut ♬ original sound - miraclecardcare

FIXING LIFTED EDGES/CORNERS: 

STEP 1: 

Place penny sleeve over lifted area and blow a couple breaths of hot air to that area with a straw as shown in demo video. Let card rest there for approximately 10 minutes. 

STEP 2: 

ALWAYS MAKE SURE YOU ARE WORKING ON THE BACK SIDE OF THE PLATES SO THE LOGOS ARE FACING OUT. MAKE SURE BOTH PLATES AND CARD ARE WIPED DOWN AND 100% DIRT AND DUST FREE SO YOU DO NOT PRESS ANY DIRT INTO YOUR CARD. 

STEP 3: 

Place the card in between the plates (LOGOS FACING OUT). Place the 4 smaller clamps around the plates. PLACE THE BIGGER CLAMPS RIGHT ON THE TROUBLED AREAS. Let the card rest there for approximately 12-24 hours. 

REPEAT STEPS 1-3 AS NEEDED